Elation VOLT Q5E, User Manual

Page: 17 / 26

17
The Secondary unit receives data from the Primary unit according to the group which the
Secondary unit was assigned to. If e.g. a Secondary unit is set to “ Secondary 1 ” in the menu
“ SetSecondary ”, the Primary unit sends “ Prog 1 ” to the Secondary unit. If set to “ Secondary
2 ”, the Secondary unit receives “ Prog 2 ”. To start an Auto Program proceed as follows:
1. Secondary Setting
Select “ FuncMode ”.
Press ENTER to confirm.
Select “ SetSecondary ”.
Press ENTER to confirm.
Select “ Secondary 1 ”, “ Secondary 2 ” or “ Secondary 3 ”.
Press ENTER to confirm.
Press MODE/ESC in order to return to the main menu.
2. Automatic Program Run
Select “ FuncMode ”.
Press ENTER to confirm.
Select “ AutoProg ”.
Press ENTER to confirm.
Select “ Primary ” or “ Alone ”.
Press ENTER to confirm.
Press MODE/ESC in order to return to the main menu.
3. Program Selection for Auto Pro Part
Select “ EditProg ”.
Press ENTER to confirm.
Select “ Sel Prog ”.
Press ENTER to confirm.
Select “ ProPart1 ”, “ ProPart2 ” or “ ProPart3 ”, and select which Secondary program is to be
sent. Selection “ Prog 1 ” means, that the Secondary unit runs the same program as the primary
units.
Press ENTER to confirm.
Press MODE/ESC in order to return to the main menu.
SYSTEM MENU
EDIT PROGRAM
– Record Controller – Working With Built In Programs
A Primary unit can send up to 3 different data groups to the Secondary units, i.e. a Primary unit
can start 3 different Secondary units, which run 3 different programs. The Primary unit sends
the 3 program parts in a continuous loop.
AUTO PRO
PART 1
PART 2
PART 3
AUTO PRO
PART 1
PART 2
PART 3
AUTO PRO
PART 1
PART 2
PART 3