25
PERSONALITY – Service Setting - RDM PID
Select various submenus via RDM (Remote Device Management), which provides the
ability to control the device remotely while connected to a DMX-bus. ANSI E1.20-2006 by
ESTA specifies the RDM standard as an extension of the DMX512 protocol. Manual
settings like adjusting the DMX starting address are no longer needed. This is especially
useful when the device is installed in a remote area.
RDM ready and conventional DMX devices can be operated in one DMX line. The RDM
protocol sends its own packages in the DMX512 data feed and does not influence
conventional devices. If DMX splitters are used and RDM control is to be used, these
splitters must support RDM. The number and type of RDM parameters depend on the RDM
controller being used.
PERSONALITY - Reset Default (011)
ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION.
NOTE: SAVED WHITE BALANCE IS ERASED AFTER A RESET IS PERFORMED.
This function restores all fixture settings to the factory default settings.
The password is
011
and must be entered each time a reset is performed.
EFFECT ADJUST – Test Channel
Select/auto test each individual channel function independently from the control board.
EFFECT ADJUST – Manual Control
Select and manually test and fine adjust each individual channel function
Independently from DMX control board. This function will center PAN and TILT motors and
set dimmer to 100%. PAN and TILT functions will still operate if the fixture needs to be
positioned to a flat clear surface. With the individual functions, you can focus the light on a
flat surface (wall) and perform fine adjustments.
EFFECT ADJUST – Calibration
ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION.
This function allows small adjustments to be made to the effect wheels (Color, Gobo, Shutter, etc.) to
compensate for misalignment and/or when a sensor has been knocked slightly out of position.
Because improper use of this function can result in undesired operation of this fixture compared to
others being used at the same time, this function has been password protected. The password is
050
and must be entered each time the calibration menu function is entered. Because this can be
an extremely detailed procedure, careful consideration must be used before making any changes.
Please contact our customer support team for step-by-step instructions.
Summary of Contents for PLATINUM HFX
Page 1: ...PLATINUM HFX user manual EL AT IO N PLATINUM HFX user manual...
Page 42: ......
