w w w . e l a t i o n l i g h t i n g . c o m
44
PLATINUM FLX™ User Manual
E R R O R C O D E S
When power is applied, the unit will automatically enter a
“Reset/Test”
mode. This
mode brings all the internal motors to a home position. If there is an internal problem
with one or more of the motors an error code will flash in the display in the form of
“XXer”
were as XX will represent a function number. For example, when the display
shows
“0Er”
it means there is some type of error with the Pan motor. If there are
multiple errors during the start-up process they will all flash in the display. For
example: if the fixtures has errors on
Channel 1
,
2
, and
5
all at the same time, you will
see the error message
“01Er”,
“02Er”
, and
”05Er”
flash repeated 5 times.
If an error does occur during the initial start-up procedure the fixture will
self-generate a second reset signal and try to realign all the motors and correct the
errors. If the error persists after a second attempt a third attempt will be made. If
after a third attempt all the errors have not been corrected the fixture will make the
following determinations:
3 or More Errors -
The fixture cannot function properly with three or more errors
therefore the fixture will place itself in a stand-by mode until subsequent repairs
can be made.
Less Than 3 Errors -
The fixture has less than 3 errors; therefore most other functions
will work properly. The fixture will attempt to operate normally until the errors can
be correct by a technician. The errors in question will remain flashing in the
display as a reminder of internal errors.
PAN Er
Gobo Wheel 1 Er
Focus Er
TILT Er
Gobo Rot.1 Er
Zoom Er
Cyan Wheel Er
Gobo Wheel 2 Er
Flow Control Er
Magenta Wheel Er Prism1 Er
LightSource Er
Yellow Wheel Er
Prism Rot.1 Er
LightPipe Er
CTO Wheel Er
Prism2 Er
Color Wheel Er
Prism Rot.2 Er
