Elation Professional • Los Angeles, CA.
Error! Reference source not found.
/
Error! Reference source not found.
)
14
Without mounting bar
1.2 Secure the Device
Regardless of the mounting method of the Impression 120RZ you'll have to use
a stipulated safety wire. Therefore you have to pull the safety wire through to
two provided holes on the bottom side of the system and connect it with the
truss-support. Pay attention to a safe and proper fastening. Install a safety wire
that can hold at least 10 times the weight of the fixture. Never use the carrying
handles for this purpose.
1.3 Connections
1.3.1 Power Supply
~100-240 Volt AC, 50-60 Hz, earth contact type plug - Powercon
Connected load 350 VA (W)
<=>
T5A (micro-fuse 5x20mm)
Please see printing on the case for the right electronic supply!
Disconnect from the mains supply for changing the fuse and use
only the above described micro-fuse type.
1.3.2 DMX
USITT DMX-512 Standard input/output in 3 pole connectors.
3 pole: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+]
The DMX- Addressing starts at the DMX- Address [001].
