©Elation Pr
o
fessionals® - www.elationlighting.com - Instruction Manual Page 10
©Elation Pr
o
fessionals® - www.elationlighting.com - Instruction Manual Page 9
3. Press ENTER to confirm. To make the LED display reappear
after it has turned off, press any button.
rFnd -
In this mode you can set up the transmitter and
reciever connection. You can also set the number of RF
controllers that are able to control the fixture. See page 11
for RF controller functions.
1. Press the MENU button until “rFnd” is displayed, press
ENTER.
2. “rF X” will now be displayed, “X” representing a number
between 1-3. You are able to have up to 3 controllers ready to
control this fixture. Press the UP or DOWN buttons to set the
amount of controllers.
3. When you have found your desired setting press the ENTER
button. Once you have pressed ENTER the display will start to
blink fast, immediately press any button on the corresponding
controller(s) to set up the signal connection.
4. If you would like to disable the active controllers and clear the
connection signal, press the UP or DOWN buttons so that “CLr”
is displayed, and press ENTER.
teSt
- This function will run a self test program.
1. Press the MENU button until “teSt” is displayed, press
ENTER.
2. The fixture will now run a self test program. To stop the self
test press the MENU button.
batt -
In this mode you can check the battery status.
1. Press the MENU button until “batt” is displayed, press
ENTER.
Event Cylinder RF
System Menu
Event Cylinder RF
System Menu
2. The display will now show the battery status. Press MENU to
exit.
FhrS
- With this function you can display the running time
of the unit.
1. Press the MENU button until “FhrS” is displayed, press
ENTER.
2. The display shows the running time of the unit. Press MENU
to exit.
ver
- Use this function to display the Software version of
the unit.
1. Press the MENU button until “ver” is displayed, press
ENTER.
2. The display will show the software version.
