7
S A F E T Y G U I D E L I N E S
RISK GROUP 3 - RISK OF EXPOSURE TO ULTRAVIOLET UV
RADIATION! FIXTURE EMITS HIGH INTENSITY WAVELENGTH OF
ULTRAVIOLET UV LIGHT FROM THE UV COLOR FILTER. WEAR
PROPER EYE AND SKIN PROTECTION. AVOID PROLONGED PERIODS
OF EXPOSURE TO UV COLOR FILTER. AVOID WEARING WHITE COLOR
CLOTHING AND/OR USING UV PAINTS ON SKIN. AVOID DIRECT EYE
AND/OR SKIN EXPOSURE AT DISTANCES LESS THAN 11 feet (3.3m).
DO NOT OPERATE FIXTURE WITH DAMAGED/MISSING EXTERNAL
COVERS. DO NOT LOOK DIRECTLY INTO THE UV LIGHT AND/OR VIEW
UV LIGHT DIRECTLY WITH OPTICAL INSTRUMENTS THAT MAY
CONCENTRATE THE LIGHT/RADIATION OUTPUT. INDIVIDUALS
SUFFERING FROM A RANGE OF EYE CONDITIONS, SUNLIGHT EXPOSURE DIS-ORDERS, OR
INDIVIDUALS USING PHOTOSENSITIVE MEDICATION, MAY RECEIVE DISCOMFORT IF EXPOSED TO
THE ULTRAVIOLET UV LIGHT EMITTED FROM THE UV LED.
DO NOT TOUCH
the fixture housing during operation. Turn OFF the power and allow approximately 15 minutes
for the fixture to cool down before serving.
DO NOT
shake fixture, avoid brute force when installing and/or operating fixture.
DO NOT
operate fixture if the power cord is frayed, crimped, damaged and/or if any of the power cord
connectors are damaged and do not insert into the fixture securely with ease.
NEVER
force a power cord
connector into the fixture. If the power cord or any of its connectors are damaged, replace it immediately with
a new one of similar power rating.
DO NOT
block any air ventilation slots.
All fan and air inlets must remain clean and never blocked.
Allow approx. 6” (15cm) between fixture and other devices or a wall for proper cooling.
When installing fixture in a suspended environment, always use mounting hardware that is no less than M10 x 25 mm,
and always install fixture with an appropriately rated safety cable.
Always disconnect fixture from main power source before performing any type of service and/or cleaning
procedure. Only handle the power cord by the plug end, never pull out the plug by tugging the wire portion of
the cord.
During the initial operation of this fixture, a light smoke or smell may emit from the interior of the fixture. This is a
normal process and is caused by excess paint in the interior of the casing burning off from the heat associated
with the lamp and will decrease gradually over time.
Consistent operational breaks will ensure fixture will function properly for many years.
94 lbs. (42.6kg)
