640K RAM,
VGA monitor
Printer cable no longer than 2 meters
3. Hardware Installation
To short the desired mode slot shown in Fig. 1 with the jumper cap
To connect the PC and the unit with a printer cable, if collaboration of PC and the unit
is required
To insert the DC power adapter into the wall plug on the left hand side of the unit
Note:
To connect the printer cable before the power cable,
DWTR executes a self diagnosis for a few seconds as the power is supplied,
Never ever to put a programmed device on the texttool before the self
-diagnosis finishing.
4. Software Installation
Just execute the “setup.exe” file from the disk and then follow the step by step indications
to the end.
5. What is the self-diagnosis?
To check the buffer of DWTR. The LED is off if the check succeeds, otherwise it will
quickly blink.
To program virtually in order to sink the residual power produced by power-on. It is
the reason why users can not put a programmed device on the texttool before the
self-diagnosis finishes.
7
