5
Life Risk
You have to observe the regulations of BGV C1 (formerly VBG 70) and
EN60598-2-17 Installations are to carry out by skilled personnel only.
!
2.1. Overhead installation
The suspension devices have to be build and me-
asured
so they can withstand for an hour the tenfold
of the payload without suffering a permanent detri-
mental deformation.
Basic installation has to be made by using a se-
cond separate suspension.
This can be e.g. asui-
table net. The second suspension must be designed
and attached so no part of the installation can fall
down in case of failure.
During construction,
reconstruction and decons-
truction unnecessary stay in the range of movin
areas, on lightning bridges, under elevated work sta-
tions or any other danger zones is forbidden.
The operator is obliged to following safety-rela-
ted and mechanical facilities:
- Before the first start-up or after critical changes
before restarting it has to be checked by an expert.
- Review in the frame of the inspection test at
least all four years by an expert. .
- Review by a qualified person at least once a
year.
How to carry out the overhead installation:
In tidal fall you should install the device out of the
lounge area of people.
IMPORTANT!
Overhead installation requires a high level of experience. This includes knowledge of calculating the
payload, used installation material and safety inspections of the used material and the projector whe-
reas the required experience is not limited to this. Do not try to carry out installation yourself under any
circumstances if you are not qualified. Contact a professional installer. An inappropriate installation can
lead to injuries and/or damaged properties.
It is not allowed to install the device in the grip
area of people.
If the device may hang from the ceiling or from
high beams,
the use of truss systems is mandatory.
The device may not be installed so it can swing freely
in the room.
Please note: Crashing down items can cause
serious injuries!
Do not install the projector, if you
doubt the safety of a possible installation form!
Before installation
make sure that the mounting sur-
face has the ability to carry the tenfold point load of
the own weight of the device.
Mount the device with the mounting-bracket
to
your trussing system using an appropriate clamp.
During overhead installation the device must be
always secured by a safety rope which is desig-
ned to hold the twelvefold weight of device.
Only
safety ropes with quick-release safety fastener ele-
ments may be used. Hang up the safety rope in the
hole of the mounting bracket. Direct the rope over the
truss or an appropriate fastening point. Hang up the
end in the fastening element and tie up the locking
knott. A safety rope once exposed to failing load or
damaged may not be used furthermore.
The maximum drop exceed must not exceed
20cm.
A safety rope once exposed to failing load or
damaged may not be used furthermore.
Adjust the desired inclination angle via the moun-
ting bracket and tighten the screw.
