OWNER’S MANUAL
EL–NVR
9
www.elanhomesystems.com
BEGINNING USING THE NVR
Important!
•
It is recommended to use the ELAN Controller for setup of ELAN NVR and Cameras
•
If installing an ELAN Cameras and/or ELAN NVR with an ELAN Controller, please refer to the “ELAN
Surveillance” Integration Note for setup and software configuration
•
ELAN Integration Notes are served through the ELAN tools and on
elanhomesystems�com/dealer-
resources
The software configuration information in this document can be used to extend device control parameters
for use within an ELAN controller environment, or for operating this hardware independent of an ELAN
controller�
You will see the following screen through the HDMI or VGA connection when the NVR is powered ON:
The information shown on the top of the screen is described as follows:
0.00/1000 (100) Mbps:
The left side of the slash is the combined transmission rate of all channels, and the right side is the your
network speed�
HDD (1):(2)%:
1� Shows the current number of the hard drive being used for recording
2� The storage capacity used as a percent (%)
