13
contact
EL-4KM-VW44
USER MANUAL
NOTE:
THE BUTTON PRESS SEQUENCE SHOULD BE FINISHED IN 5 SECONDS,
OTHERWISE THE OPERATION IS DISCARDED
Infrared Remote Control
MODE SELECTION
A
Switches between Matrix modes:
MX - Matrix mode
VW - Video Wall mode
MV - Multi-View mode
HDMI/VGA INPUT TYPE SELECTION
B
Inputs 1-4 can be assigned as EITHER
HDMI or VGA video. This selection can be
acheived for each input.
HDMI selection - Press an input
button followed by the HDMI button.
VGA selection - Press an input
button followed by the VGA button.
OUTPUT AND INPUT SELECTION
C
Selects the zone OUTPUT you wish to
change the source on (Numbers 1 - 4
correspond to the zone outputs 1 - 4)
B
Selects the source INPUT you wish to
change on the selected zone (Numbers 1
- 4 correspond to the source inputs 1 - 4)
EXAMPLE
To switch source 2 to zone 4 you would
press 4 in the output section (C) followed by
pressing 2 in the Input section (B).
ALL button:
The all button selects all the
inputs or outputs in its corresponding box.
Example: (The “All” button in the Output box
selects all the zones so all zones will change
to what source input is selected next).
EDID SET UP
The EL-4KM-VW44 provides a comprehensive
range of EDID settings. Below are three
examples of how to deploy the desired EDID
setting when using the supplied remote.
1.
Fix EDID to an Input or ALL inputs:
Press the desired video resolution
button (1080i / 1080p etc), then select
the source input you want this EDID
information allocated to by pressing the
INPUT 1 – 4 or the ALL button
2.
Copy EDID of Output-X to an Input
or ALL:
Press the COPY but-ton then
select the OUTPUT you wish to copy the
EDID information from, then select the
source input you want to copy this EDID
to by selecting the INPUT 1-4 or the ALL
button.
3.
User defined EDID to an Input or ALL
inputs:
Press USER1 / USER2 button
then select the source you wish to assign
this EDID to by select-ing INPUT 1-4 or
the ALL button
B
C
D
A