6
5. Operation Instructions
6. Installation Instructions
• The moving head is for spot effect for on-site decoration purpose.
• Don’t turn on the fixture if it’s been through severe temperature difference like after transportation becau-
se it might damage the light due to the environment changes. So make sure to operate the fixture until it
is in normal temperature.
• This light should be keep away from strong shaking during any transportation or movement.
• Don’t pull up the light by only the head, or it might cause damages to the mechanical parts.
• Don’t expose the fixture in overheat, moisture or environment with too much dust when installing it. And
don’t lay any power cables on the floor. Or it might cause electronics shock to the people.
• Make sure the installation place is in good safety condition before installing the fixture.
• Make sure to put the safety chain and check whether the screws are screwed properly when installing
the fixture.
• Make sure the lens are in good condition. It’s recommended to replace the units if there are any dama-
ges or severe scratch.
• Make sure the fixture is operated by qualified personnel who know the fixture before using.
• Keep the original packages if any second shipments is needed.
• Don’t try to change the fixtures without any instruction by the manufacturer or the appointed repairing
agencies.
• It is not in warranty range if there are any malfunctions from not following the user manual to operate or
any illegal operation, like shock short circuit, electronic shock, lamp broke, etc.
• Before mounting the fixture to any surface, make sure that the installation area can hold a minimum
point load of 10 items the device’s weight.
• Fixture installation must always be secured with a secondary safety attachment, such as an appropriate
safety cable.
• Never stand directly below the device when mounting, removing, or servicing the fixture.
• From a ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept at least
0.5m (1.5ft) away from any flammable materials (decoration etc.).
• Always use and install the supplied safety cable as a safety measure to prevent accidental damage and/
or injury in the event the clamp fails.
Caution!
For added protection mount the fixtures in areas outside walking paths,
seating areas, or in areas were the fixture might be reached by unauthori-
zed personnel.
!
