3
1. Safety Instructions
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written
in this user manual.
• If the device has been exposed to temperature changes due to environmental changes, do not switch it
on immediately. The arising condensation could damage the device.
• Leave the device switched off until it has reached room temperature.
• This device falls under protection-class I. Therefore it is essential that the device be earthed.
• The electric connection must carry out by qualified person.
• The device shall only be used with rate voltage and frequency.
• Make sure that the available voltage is not higher than stated at the end of this manual.
• Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case, re-
placement of the cable must be done by an authorized dealer.
• Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
• During initial start-up some smoke or smell or smell may arise. This is a normal process and does not
necessarily mean that the device is defective, it should decrease gradually.
• Please don’t project the beam onto combustible substances.
• Fixtures cannot be installed on combustible substances, keep more than 50cm distance with wall for
smooth air flow, so there should be no shelter for fans and ventilation for heat radiation.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer of his service agent or a similar qualified person in order to avoid a hazard.
Caution!
Be careful when operating this fixture. High voltage can cause dangerous
electric shock when manipulating wires.
!
Please review the following before you start
