Software Configuration – FDM-SW2
In the lower-left corner, above the button activation of FDM-SW2, there is the
Set
button; clicking it
displays the program setting window shown below.
To correctly configure the communications you need to click the
Remote Control
tab and then tick
the
Enable Omnirig Control
control box at the top center of the window. Then you will have to
confirm with the OK button.
If you act in
auxiliary connected receiver
or
auxiliary switched receiver
modes, the configuration
ends here.
If you use the
Panadapter
mode, you must click the
Advanced
tab to display the screen below.
3
