ELAD FDM-DUOr
Firmware Update - Rev. 1.1 - 07/2019
© 2019 ELAD S.r.l. All rights reserved. No part of this document may be reproduced, published, used, disclosed or disseminated
in any form or by any means, electronic, photocopying or otherwise, without prior written permission of ELAD S.r.l.
8
4.3
Update with Flash Magic Classic Version 11
Run Flash Magic 11 and set the following parameters.
In the “Step 1 – Communication” section :
select LPC1766,
COM Port: the CAT USB COM port,
Baud Rate: 230400,
Interface: None (ISP).
In the “Step 2 – Erase” section :
check “Erase all Flash+Code Rd Prot”.
In the “Step 3 – Hex File” section :
click on Browse and select the update “.hex” file.
In the “Step 4 – Options” section :
check “Verify after programming”
Check the communication with the FDM-DUO clicking on “ISP” and then on “Read Device Signature”. If
the communication with the FDM-DUO is working, a new window with some device information is
opened.
If the communication is working it is possible to proceed with the firmware update. Click on “close” on
the “Device Signature” window. In the Flash Magic main window, click on “Start” to begin the
programming.
