Connection and starting
27
The volume of the complete subwoofer /
satellite system may be altered by means of
the remote control (“VOLUME”).
The volume of the satellites is changed in the
same amount as the volume of the sub-
woofer.
If the subwoofer is started for the very first
time, the volume is set to -10 dB.
LED blinking sequence:
Volume –
The dynamic loudness function („LOUD-
NESS“) may also be toggled by means of the
remote control.
On every start-up this function is activated or
deactivated corresponding to the DYN
LOUDNESS DIP switch on the rear panel of
the speaker.
The default selection EXW is DYN LOUD-
NESS = on.
LED blinking sequence:
Loudness ON
Loudness OFF
The relative level of the subwoofer is ad-
justed by this control; it does not influence
the level of the satellites.
The adjustment should balance the bass with
the mid/high frequencies from the satellites.
Generally the subwoofer level should be
adjusted so that it does not dominate. Too
much bass will quickly muddy up the sound,
clarity is lost.
Once you found a good sounding balance,
stay with it.
LED blinking sequence:
Entering subwoofer Volume mode
Leaving subwoofer volume mode
The powered speaker may be switched on or
set to standby-mode by means of the „ON /
STBY“-switch on the remote control.
During standby mode the subwoofer’s power
consumption is less than 0.5 watts only!
A MUTE-function is also provided (“MUTE /
BT”). This function turns down the volume to
a very low level.
LED blinking sequence:
Subwoofer is booting
Subwoofer is shutting down
MUTE ON
MUTE OFF
