ELAC Alchemy DPA-2 Amplifier | www.elac.com | Page 4
Controls and Indicators
1.
POWER Button—Used to power the amplifier on and off
2.
MUTE Indicator — This LED will illuminate when the MUTE function is active
3.
RCA Input Indicator—This LED will illuminate when the RCA inputs are selected as the active inputs
4.
XLR Input Indicator—This LED will illuminate with the XLS inputs are selected as the active inputs
5.
L+R (Mono) Indicator—This LED will illuminate when the Mono function is active
6.
+6db Indicator—This LED will illuminate when the GAIN function is active
7.
MUTE Button—Used to activate the MUTE Function which will disable all output of the amplifier when
active
8.
INPUT Button—Used to switch between the RCA and XLR Inputs on the rear of the amplifier
9.
MONO Button—Used to switch the amplifier from Stereo to Mono (Double the power). This mode
requires a different wiring connection. Please refer to the diagram on the rear of the amplifier for more
information
10.
GAIN Button—Used to put the amplifier in High Gain mode. Use this function if you are not getting the
appropriate volume output from the amplifier.
11.
XLR Inputs—Used when connecting a balanced XLR based Pre-Amplifier to the DPA-2 Amplifier
12.
RCA Inputs—Used when connecting an unbalanced RCA based Pre-Amplifier
13.
12 Volt Trigger In/Out— Used when you want another device to power on/off your DPA-2.
14.
Speaker Outputs— Used to connect the amplifier to your speakers. Please refer the diagram on the
rear of the amplifier for correct speaker connection methods for both Mono and Stereo Setups.
15.
AC Inlet—Used to connect the amplifier to the main power
16.
OEL Display—Use to display various information for setup and usage
