EN
OPERATION
HANDLING DURING NORMAL OPERA-
TION
Start & stop
OFF/full and half speed
Adjusting the indoor temperature
Set the thermostat to the desired temperature in the
range +8-32°C.
Setting the desired power level
Select either 9 or 18 kW.
Replacement of filter
• Replace the filter every 4 weeks or as necessary.
The filter must be fitted so that the arrow on the
filter points inwards towards the machine. Always
use original filters from El-Björn.
• Turn off the machine using the ON/OFF switch.
• Restart the machine.
NOTE!
Use a respirator and gloves when replacing
the air filter Put the spent filter in a bag and close it.
HANDLING DURING ABNORMAL OPER-
ATION
Check that the fuses in the nearest electrical cabinet
have not blown and that the residual current device
has not tripped
Check the fuses inside the machine.
The overheating protector will reset automatically
when the machine has cooled down.
If this does not remedy the problem contact a
Cooling down
IMPORTANT!
The heating elements get very hot (about 300°C),
so it is vital that they cool down after use in order
to maximise the machine’s lifespan. This must be
done every time the machine is turned off prior to
filter replacement or before the machine is moved.
DEINSTALLATION
Switch off the machine as described above (this extends the life of the machine). Disconnect the elec
-
trical cable. The machine can now be transported.
•
Keep the machine in good condition by ser-
vicing it regularly.
• Before using the machine, always check the
operation of the main components (fan and
heating elements).
• Check and tighten the heating elements.
• Check and tighten electrical connections on
the machine.
• Check that there are no loose screws and that
all parts are properly attached.
• Make sure there are no defective parts that
could compromise safety.
• In the event of abnormal noise or vibrations,
switch off the machine immediately and make
SERVICE
MAINTENANCE
Day-to-day maintenance should be performed on site by an appointed operator.
NOTE! After the first season of use it is especially important to tighten electrical connections,
the fan motor mounting and the electric element nuts and connections.
Warning!
To eliminate the risk of injury, always disconnect from the electrical supply before starting any
service work. The following points must be checked by the operator.
sure the fault is repaired.
• Filters should be replaced after around 4
weeks or as required.
• Never use a machine that is damaged.
• Always mark a defective machine with “Not to
be used” until it has been repaired.
Summary of Contents for EB15126
Page 1: ...TF 18EL EBS This product is only suitable for well insulated areas or occasional use Manual...
Page 30: ......
Page 31: ......
Page 32: ......
