- 12 -
CONNECTING THE D-RGB LED STRIP
STEP 1
Plug the
4-pin D-RGB
connector from the GPU water block to the
D-RGB Header
on your motherboard or controller. The LED strip will
work only if the pin layout on the header is as follows:
+5V, Data,
Empty, Ground
.
Incorrect installation or installation to a wrong header can
damage to the LED strip or the header itself!
STEP 1
If you want to replace the D-RGB LED strip, you must remove the two
(2) standoffs shown in the picture using a 6mm wrench. Remove the
stickout and replace the LED strip.
Once you have replaced the LED strip, align the holes on
the stickout with holes on the top plate, and tighten the
standoffs evenly.
STEP 1
STEP 1
D-RGB HEADER
RGB HEADER
REPLACING THE LED STRIP (Optional)
M4/M2.5 x 13.5
(LONGER) STANDOFF