- 6 -
INSTALLING THE WATER BLOCK
STEP 1
PLACING THE BLOCK ON TO THE GRAPHICS CARD
Carefully position the water block with preinstalled standoffs on to
the graphics card. During this process please make sure you align
mounting holes on the PCB with holes on the water block (same
applies for other tops). Also pay attention not to use too much
force by pressing the block down to the PCB. Chip dies are prone
to cracking.
STEP 1
M2.5 x 6 AX1
13 pcs
M 2.5 PVC washer
16 pcs
M2.5 x 4 AX1
16 pcs
M2.5 x 8 AX1
2 pcs
M3 x 4 DIN7985
2 pcs
EK Plug G1/4
2 pcs
2.5 mm Allen Key
1 pc
6 mm Allen Key
1 pc
BAG CONTENT
Bag content is universal for all water blocks, you may not need all screws.
M2.5 Helix nuts
6 pcs
Thermal Grease
1 pcs
