- 7 -
STEP 9: PUMP – CONNECTING
CABLES
D-RGB Connector
4-pin
PWM
STEP A:
Plug the 4-pin PWM connector from the pump
to the motherboard.
STEP B:
Plug the 3-pin connector from the pump D-RGB LED
light to the D-RGB HEADER on the motherboard.
The LED will work if the pin layout on the header is as
follows: +5V, Digital, empty, Ground. Alternatively, with
some motherboards you can use a VDG connector
instead of a D-RGB to connect the LED.
Please ensure that the arrow indicated on
the connector is plugged into the +5V line
as indicated on your motherboard. If you
put LED Diode to the 12V RGB HEADER
you can damage the LEDs.
Connector is the same on D-RGB and RGB
versions, but D-RGB version has 3 cables
from connector to PCB; RGB version has
4 cables. If you connect D-RGB led to
ordinary RGB header you can damage
your motherboard or LED strip.
STEP 8: INSTALLING THE ASSEMBLY
OF FANS AND RADIATOR INTO A PC
CASE
Attach the assembly of radiator and the fan(s)
to the PC case with the UNC 6-32 x 6mm
screws.
EK-AIO Nucleus 120
EK-AIO Nucleus 240
EK-AIO Nucleus 360
UNC 6-32 x 6 mm
(4x)
UNC 6-32 x 6 mm
(8x)
UNC 6-32 x 6 mm
(12x)
Radiator on top (recommended)
Vertical placement of the radiator with
tubing at the bottom (recommended)
Avoid vertical placement of the radiator
with tubing at the top
Avoid radiator at the bottom
