CIRCULAR PEARL EMERGENCY INSTALLATION INSTRUCTIONS
5. MOUNTING
Before you start mounting your Circular, the access point for the terminal block wiring must be chosen.
There are three different access points
(A, B, C)
, option C is specificaly for conduit entry.
1.
Drill a hole through the Circular base in the desired position. Route the wiring for the terminal block
through the holes and the supplied weatherproof gland.
2.
Move the Circular into position on the ceiling and mount by fastening the screws securely to the flat
surface with the use of the supplied washers.
3.
Wire the terminal block as shown in
section 6 (page 5)
, tighten cables into the strain relief and
reassemble cover as in steps 2 and 3.
CEILING MOUNT
Figure 2: Ceiling mount
4
6 gage screws
not supplied
Strain relief
NOTE:
Optional maisonary anchors/raw plugs are supplied
A
B
C
Washers
supplied
