7.0 OPERATING THE APPLIANCE
GB IE
Read All Instructions Before Use
Check that the heater outlet grille, mounted beneath the appliance, is not covered or obstructed in anyway, and ensure the power
to the fire is switched on.
Control Panel
The control panel is located underneath the grill at the top of the appliance. This panel contains the buttons to properly operate the
electric fireplace.
Remote Control
The fire is supplied with an IR multifunction remote.
The remote control has an effective range of up to 13 feet.
Before the remote will operate the plastic insulating sheet needs
to be removed.
Battery Replacement
Battery Requirements: 3V CR2025
1. Locate and remove the battery bracket.
2. The battery has two sides, one with a button feature, and the
other is flat.
3. Insert the battery with the button side down into the battery
bracket, making sure the battery is firmly seated.
Using The Main Power Button
The main power button (1) is located on the control panel under the grill on top the of the appliance. Pressing the main power button
(1) once turns the power ON.
Pressing the main power button (1) again will turn the power OFF.
If you find that none of the other buttons appear to work, check to make sure that the main power (1) is turned on.
Battery Disposal
Batteries must be recycled or disposed of properly. Check with your Local Authority or Retailer for recycling advice in your area.
Using the Flames Control Button
Press the flames control button (2) to turn on the ember bed
and flame effect.
Pressing the flames control button (2) once turns flames on and
lights the ember bed.
Pressing the flames control button (2) again will cycle through dif-
ferent colours of the ember bed. The colour rotation mode will
cycle through the 3 different colour settings continuously. Refer
to the table opposite for more detailed information.
Using the Heater Control Button
The heater control button (3) turns the heater on and off. With the unit
ON, press the control panel heater button (3) for 5 seconds and enter
temperature adjustment mode.
Hold button (2) down for five seconds to change from Fahrenheit to
Celsius.
Press the control panel heater button (3) to change to the desired tem-
perature. There are 10 temperature settings. Refer the table opposite
for more detailed information.
After the temperature is selected, it will stay on for 10 seconds, then
turn off.
4
©
2016 Focal Point Fires plc.
1. 2. 3. 4.
1. Main Power Button
2. Flames Control Button
3. Heater Control Button
4. Timer Control Button
5. Temperature Control Buttons
(Remote Control Only)
1.
2.
3.
4.
5.
