background image

eKM Metering Inc.

EKM Metering Inc.  –  www.ekmmetering.com  –  info@ekmmetering.com  –  (831)425-7371

Indoor Enclosure 

Spec Sheet

Parts:

#1: Hex Nut

#2: Lock Washer

#3: Small Bolt

#4: Cover Screw

#5: Enclosure Box

#6: DIN Rail

#7: Surface Enclosure Cover

Principle:

This setup is intended for indoor surface mount applications. The 

enclosure should be attached to a surface in an appropriate way at the 

discretion of the installer. Any electrical, current transformer, or 

communication wires should be routed to the enclosure via conduit. 

There are two threaded ports for conduit to enter on the top, bottom, 

and rear of the enclosure box.

Installation Instructions:

1. First choose a suitable surface to mount your enclosure on and find a 

    good way to attach the Enclosure Box(#5) to the surface. For example, 

    this can be done by drilling through the back of the enclosure box and 

    screwing to a wooden structural member.

2. Before you mount the enclosure to the surface you will need to attach

    the DIN rail(#6) inside the Enclosure Box. To do this, Insert the Hex 

    Nuts(#1) into the recesses in the back of the enclosure. This will hold 

    them in place. Now pass the Small Bolt(#3) through the Lock 

    Washer(#2), through the DIN Rail(#6), and through the Enclosure Box, 

    into the Hex Nut(#1). Use a screwdriver to tighten the bolts.

3. Now mount the enclosure to the surface you have chosen.

4. Route all of the wiring to the enclosure before you install your meter.

5. Connect the wires to your meter before you clip it onto the DIN rail.

6. When you have wired up your meter, clip it onto the DIN rail. This is

    done by inserting the top of the meter first. Then pull down on the

    spring loaded clip at the bottom to get it to go behind the bottom of

    the DIN Rail. If this is done correctly the meter should now be securely

    mounted.

7. At this point you can turn the electricity on and make sure that your

    meter powers on and that you are getting good reads. If you are using

    a smart meter you can also test that your meter is communicating

    properly.

8. When you are satisfied that everything is connected appropriately you

    can install the Surface Enclosure Cover(#7) using the four Cover 

    Screws(#4) and you should now be finished installing your meter and 

    Indoor Enclosure.

#1 #2 #3 #4

x2

x2 x2 x4

#1

#5

#7

Surface Mount

#6

#2

#3

#4

#4

Specifications:

• Model: EKM-IENC

• Dimensions: 6.75" Tall x 4.5" Wide x 2.5" Deep

• Weight: 1Lb 6oz

• Materials: ABS plasic box and covers, steel hardware

• Meters Supported: Any electric meters designed by EKM Metering, 

  including up to four EKM-15E(note that even four of these will not fill the 

  faceplate hole in the enlosure covers).

Reviews: