13
9.Maintenance
The parts on the vehicle, especially safety devices, shall not be modified without permission,
and the driving speed of the vehicle shall not be changed. All parts supplied by the original
manufacturer are subject to strict quality inspection. To ensure the safety and reliability of
the vehicle, please use the original accessories. Replacement parts, including all oil, must be
collected and processed in accordance with local environmental and health laws and
regulations.
9.1Safety procedures for repair and maintenance
Maintenance technician:
The maintenance and service should only be performed by
special personnel trained by the manufacturer. After the technician sent by after-sales
department of the manufacturer completed maintenance and servicing work, they should
sign on the service log.
Cleaning Operation:
Flammable liquid cannot be used for cleaning the stacker. Before
cleaning, take safety precautions to prevent electric sparks (e.g. sparks caused by short
circuit). When operating the accumulator, connectors on it must be disconnected. Use soft
air suction or compressed air, non-conductive and anti-static brushes to clean electric and
electronic components.
Operation of Electric System:
Operation on the electric system should only be performed
by specially trained personnel. Before performing any operation on the electric system,
precautions must be made to prevent electric shock. When operating the accumulator,
connectors on it must be disconnected.
Installation:
When repairing or replacing hydraulic components, electric and electronic
components, make sure to install them back to their original positions.
Wheels:
Quality of the wheels has significant effect on stability and driving performance of
the stacker. Modification on wheels can be performed only with the approval from the
manufacturer. When replacing wheels, ensure that the stacker is levelled as delivery
state(wheels must be replaced in pairs, i.e. replace right wheel together with left one).
Lifting chain and rollers:
Chain and rollers will be worn quickly without good lubrication.
Perform periodic lubrication according to following maintenance table. Shorten the
lubrication period under adverse operation conditions (such as in dusty and hot
environment).
Hydraulic oil pipe:
The oil pipe must be changed every 6 years. When change the hydraulic
assembled parts, the oil pipe should be also changed.
Summary of Contents for EP20D Series
Page 12: ...9 6 Electrical Schematic Diagram ...
Page 13: ...10 7 Hydraulic Schematic Diagram ...
Page 18: ...15 ...