EKKO EOP68, Manual

Page: 27 / 33

23
2
Check if there any damage and leakage for Hydraulic
connector and tubing . •
3 Check hydraulic oil level and refill if necessary. •
4 Refill hydraulic oil(12 months or 1500 working hours)
•
Mechanical system.
5 Check the fork for deformation and cracks •
6
Check the base for deformation and cracks •
7
Check all screws are fully fixed
•
8 Check the mast & chain for corrosion. Deformation or
damage ,And replace if necessary
•
9
Check the gear box for noise and leakage
•
10
Check the wheels for deformation and damage and
replace if necessary
•
11
Lubricated steering bearing •
12 Check and lubricate the pivot point •
13
Grease fitting •
14
Protect, protective plates and replace it if they are
damaged
•
Electric system
15
Check the wires for damage
•
16
Check electrical connections and terminal conditions •
17
Check the function of Emergency stop switch
•
18
Check the electric motor for noise and damage •
19
Check the display
•
20
Check if the fuse is used correctly and replace if
necessary
•
21 Detection buzzer •
22
Check the current contactor •
23 Check the frame for leaks (Insulation test ) •
24
Check the function and wear of the accelerator •
25
Check the electrical system of the drive motor
•
Braking system
26 Check the braking performance •
battery
27
Check the battery voltage
•
28
Clean and grease the terminal ,Check for corrosion and
damage
•
29
Check if battery box damage •
Charger
30
Check if the main power cord is damage
•
31 Check the start protection procedure during charging •
Function
32 Detection buzzer •
33
Check the air gap for electromagnetic braking •
34
Check emergency braking function
•
35
Detect reverse braking and regenerative braking •
36
Check steering function
•
37 Check lift up & lift down function •
38
Check key switch for damage and function •
39 Check speed limit switch(lifting height >~400mm) •