_TECNOEKA Srl___________________________________________________________ use and instruction manual _
_ page 6 _________________________________________________________________________________________
-
Maintenance, adaptation to another type of gas, installation, and the functional check
must be performed only by qualified personnel authorised by the manufacturer. Install
the appliance in a suitable ventilated room and put it into operation while observing the
laws in force. Insist on original spare parts and, after replacing and/or adjusting a part,
such as primary air, make sure that it is sealed with paint to prevent any tampering. We
advise you to take out a maintenance contract.
-
This appliance is designed for cooking or heating foods. Do not use it for other purposes
– all other uses are considered improper. The appliance is intended for collective and
professional use and must be utilised by personnel trained to use it.
-
When the tilting door is wide open, do not put anything on the surface, because the
door hinges could be irreparably damaged
-
Before every oven cleaning or maintenance job, switch off electrical power, and shut off
gas and water supplies.
N.B.:
N.B.:
N.B.:
N.B.: Improper or incorrect use an
Improper or incorrect use an
Improper or incorrect use an
Improper or incorrect use and failure to observe the installation instructions shall release
d failure to observe the installation instructions shall release
d failure to observe the installation instructions shall release
d failure to observe the installation instructions shall release
the manufacturer from all responsibility.
the manufacturer from all responsibility.
the manufacturer from all responsibility.
the manufacturer from all responsibility.
1.2
1.2
1.2
1.2 Technical data
Technical data
Technical data
Technical data----plate and warning
plate and warning
plate and warning
plate and warning----plate
plate
plate
plate
The technical data-plate (Fig.1) and the plate with the installation warnings (Fig. 2) are
permanently and visibly fitted on the rear panel of the oven. An additional plate – to be
removed with all packing material – is situated inside the packing.
Fig. 1
Fig. 1
Fig. 1
Fig. 1
150÷250 kPa
150÷250 kPa
150÷250 kPa
150÷250 kPa
(1,5÷2,5 bar)
(1,5÷2,5 bar)
(1,5÷2,5 bar)
(1,5÷2,5 bar)
