- 12 -
FITTINGS AND TUBING
CONNECTING THE D-RGB LED STRIP
STEP 1
Plug the
4-pin D-RGB
connector from the GPU water block to the
D-RGB Header
on your motherboard or controller. The LED strip will
work only if the pin layout on the header is as follows:
+5V, Data,
Empty, Ground
.
Incorrect installation or installation to a wrong header can
damage to the LED strip or the header itself!
STEP 1
D-RGB HEADER
RGB HEADER
STEP 1
Screw-in two (2) G1/4 threaded male fittings. Attach the liquid
cooling tubes and connect the water block to the cooling loop.
Do not forget to plug the remaining two openings with
enclosed EK-Plug G1/4 or its equivalent.
EK recommends using EK fittings with all EK water blocks.
CAUTION: When using connectors other than EK fittings,
pay special attention to the length of the fittings’ male G1/4”
thread – 5mm is the maximum G1/4” thread length allowed!
STEP 1
TUBING
EK- PLUG
G1/4
EK-FITTING
