- 15 -
CONNECTING THE D-RGB LED STRIP
STEP 1
Plug the
3-pin connector
from Water block’s D-RGB LED light to
the
D-RGB HEADER
on the motherboard. The LED will work if the
pin layout on the header is as follows:
+5V, Digital, empty, Ground
.
Please ensure that the arrow indicated on the connector
is the plugged into the +5V line as indicated on your
motherboard. Failure to do so will damage your
motherboard or the LED strip.
STEP 1
D-RGB HEADER
RGB HEADER
To ensure the installation of EK components was successful, we
recommend you perform a 24-hour leak test.
When your loop is complete and filled with coolant, connect the
pump to a PSU outside your system. Do not connect power to any
of the other components. Turn on the PSU and let the pump run
continuously. It is normal for the coolant level to drop during this
process as air collects in the reservoir.
Inspect all parts of the loop, and in case the coolant leaks, fix the issue
and repeat the testing process. To prevent possible damage, please
ensure that all hardware is dry before the system is powered on.
TESTING THE LOOP
