English
20
2.
CABLE
CONNECTION
The Priority Input Signal
This function is used to select which PC will have priority to control the monitor when
utilizing two PCs. The monitor constantly checks the input signals and switches
automatically in accordance with the “Input Priority” setting (see table below). Once a
priority is set, whenever a change of signal is detected at the selected input, the monitor
will switch the input to that signal.
In the case of only one signal being present at either input, the monitor automatically
detects and displays that signal.
Priority Setting
Performance
1
(SIGNAL 1 – DVI-I
Input Connector)
If signals from both inputs are present, the monitor gives preference
to Signal 1 in the following cases.
•
When the power of the monitor is turned ON
•
When the signal input to Signal 1 is changed even if active input
was Signal 2.
2
(SIGNAL 2 – D-Sub
mini 15 pin Input
Connector)
If signals from both inputs are present, the monitor gives preference
to Signal 2 in the following cases.
•
When the power of the monitor is turned ON
•
When the signal input to Signal 2 is changed even if active input
was Signal 1.
Manual
The monitor will not detect signals automatically in this mode. Select
the active input by pressing the Input Signal Selection Button on the
monitor’s control panel.
NOTE
•
When the “1” or “2” is selected, the power saving mode of the monitor activates only
if both PCs are in power saving mode.
