Chapter 5 Troubleshooting
5-1. No Picture
Problem
Possible cause and remedy
1. No picture
•
Power indicator does not light up.
•
Check whether the power cord is connected properly.
•
Turn on the main power switch on the rear side of the monitor.
• Touch
.
•
Turn off the main power switch on the rear side of the monitor, and
then turn it on again a few minutes later.
•
Power indicator is lighting white.
•
Increase “Brightness”, “Contrast”, or “Gain” in the Setting menu (see
).
•
Power indicator is lighting orange.
•
Switch the input signal.
•
Turn the setting “On” for “Compatibility Mode” on the “Administrator
Settings” menu (see
“Compatibility Mode” (page 26)
).
•
Move the mouse or press any key on the keyboard.
•
Check whether the PC is turned on.
•
Turn off the main power switch on the rear side of the monitor, and
then turn it on again.
•
Power indicator is flashing orange
and white.
•
This symptom may occur during DisplayPort input. Use a signal
cable recommended by us for the connection. Turn the monitor off
and on.
2. The message below appears.
This message appears when the signal is not input correctly even
though the monitor is functioning properly.
•
This message appears when no
signal is input.
Example:
•
The message shown left may appear, because some PCs do not
output the signal immediately after power-on.
•
Check whether the PC is turned on.
•
Check whether the signal cable is connected properly.
•
Switch the input signal.
•
Turn off the main power switch on the rear side of the monitor, and
then turn it on again.
•
The message shows that the
input signal is out of the specified
frequency range.
Example:
•
Check whether the PC is configured to meet the resolution and
vertical scan frequency requirements of the monitor (see
Supported Resolutions” (page 10)
).
•
Reboot the PC.
•
Select an appropriate setting using the graphics board’s utility. Refer
to the User’s Manual of the graphics board for details.
28
Chapter 5 Troubleshooting
