www.eisenblaetter.de
20
Original instructions VARILEX
®
1100
EN
8. Accessories
Only use original Eisenblätter accessories.
Use only accessories that fulfil the requirements and
specifications listed in these operating instructions.
Cutting disc cover clip / safety cover for cut-off
grinding:
Designed for work with cutting disc and diamond cutting
discs. Once the cutting disc cover clip is fitted, the safety
cover becomes a cutting safety cover.
Art. no.
Description
65045
VARILEX
®
cut-off wheel cover clip
65048
VARILEX
®
suction cover
65041
VARILEX
®
3D ball grip
Use abrasive tools made from Eisenblätter for best work
results, such as:
• Cutting discs and rough grinding discs
• Flap discs
• Fibre discs
• Cleaning discs
• Backing plates
• Quick-change systems for discs
Note:
Accessories shown or described are not
part of the standard delivery scope of the product.
The complete program can be found on
www.eisenblaetter.de or in the catalog.
9. Initial operation
9.1 Attaching the additional handle:
Always work with the additional handle (B1)
attached! Attach the additional handle on the left
or right of the machine and secure.
9.2 Attach the safety cover:
For safety reasons, always use the safety cover
provided for the respective disc! See also chapter
8. Accessories.
Safety cover for grinding:
Designed for work with rough grinding discs, flap
sanding pads, diamond cutting discs.
See page 2, figures C, D and E:
• Push and hold the lever (C-1). Place the safety cover
in the position indicated (D).
• Release the lever (C-1) and turn the safety cover until
the lever engages.
• Push the lever and turn the safety cover until the
closed section is facing the operator (E).
• Make sure that the safety cover is placed securely:
The lever must engage and you should not be able to
turn the safety cover.
Use only grinding tools that are
covered by at least 2 mm by
the safety guard.
(Disassemble in reverse order.)
Before commissioning, check that the rated mains
voltage and mains frequency, as stated on the
type plate match your power supply.
Always install an RCD with a maximum trip current
of 30 mA upstream.
The red electronics signal indicator (B7) lights up briefly
when the mains plug is inserted in the socket, indicating
readiness for operation.
Setting speed:
Set the recommended speed at the thumbwheel (B5/
H1). (Small number= small speed; large number = high
speed)
1
2,800 min
-1
4
6,850 min
-1
2
4,150 min
-1
5
8,200 min
-1
3
5,500 min
-1
6
9,600 min
-1
Cutting disc, rough grinding disc, cup wheel, diamond
cutting disc: high speed
Brush: medium speed
Sanding plate: low to medium speed
The VTC electronics make material-compatible work
possible and an almost constant speed, even under load.
The best way to determine the ideal speed setting is by
performing a test.
Recommendation:
For demanding polishing work
in continuous use we recommend our angle
polishers VARILEX
®
POLISHER HT and VARILEX
®
POLISHER
AKKU.