EINHELL TC-CS 89, Original Operating Instructions

Page: 18 / 142

GB
- 18 -
4. Technical data
Mains voltage: ........................220-240 V ~ 50 Hz
Power input: .............................................. 600 W
Idling speed: .......................................7,200 min
-1
Cutting depth: ...................................max. 27 mm
Saw blade: ............................................Ø 89 mm
Blade holder: .........................................Ø 10 mm
Protection class: ............................................ II/
Weight: .......................................................2.2 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 62841.
L
pA
sound pressure level ........................ 94 dB(A)
K
pA
uncertainty .............................................3 dB
L
WA
sound power level ........................ 105 dB(A)
K
WA
uncertainty .............................................3 dB
Wear ear-mu ff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
Handle
Vibration emission value a
h
= 4.54 m/s
2
K uncertainty = 1.5 m/s
2
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Warning:
The vibration and noise emission levels may vary
from the level speci fi ed during actual use, depen-
ding on the way in which the power tool is used,
especially the type of workpiece it is used for.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment’s construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Setting the cutting depth (Figure 2)
•
Release the lever for adjusting the cutting
depth (4).
•
Set the cutting depth in accordance with the
scale (a).
•
Close again the lever for adjusting the cutting
depth (4).
•
When cutting wood or plastic the selected
cutting depth should be a little larger than the
material thickness.
•
To prevent damage to underlying surfaces,
the cutting depth can be set exactly to the
thickness of the material. However, this will
result in a slightly unclean cut.
Anl_TC-CS_89_SPK9.indb 18 07.05.2020 08:39:40
www.sidirika-nikolaidi.gr