GB
9
work, is imperative. The manufacturerʼs liability shall
be deemed void if the machine is modified in any
way and the manufacturer shall therefore accept no
liability for any damages arising as a result of
modifications. Even if the machine is used as
intended, certain residual risk factors cannot be
completely eliminated. For reasons of design and the
construction of the machine, the following
eventualities are possible:
앬
Contact with the diamond cutting wheel where it
is not covered.
앬
Contact with the diamond cutting wheel while it is
turning.
앬
Defective diamond tips flying off the cutting
wheel.
앬
Workpieces or parts of workpieces kicking back.
앬
Damage to hearing if the ear-muffs specified are
not used.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Important instructions
4.1. General
Please read this manual carefully and pay particular
attention to the instructions contained within it. Use
this information to get to know the machine, its
correct operation and safety regulations (see
supplementary sheet) before using for the first time.
4.2. Additional safety instructions
앬
Set up the machine on a level, non-slip floor.
Make sure that the machine does not wobble.
앬
Check that the voltage on the rating plate is the
same as your supply voltage. Only then are you
to insert the power plug in the socket-outlet.
앬
Wear safety goggles.
앬
Wear ear-muffs.
앬
Wear safety gloves.
앬
Never use cracked diamond cutting wheels.
Replace immediately.
앬
Never use segmented cutting wheels.
앬
Caution!
The cutting wheel runs on after the
machine is switched off!
앬
Never apply side pressure to the diamond cutting
wheel in order to bring it to a halt.
앬
Caution!
The diamond cutting wheel must be
cooled with water at all times.
앬
Always pull out the power plug before changing
the cutting wheel.
앬
Use only suitable diamond cutting wheels.
앬
Never leave the machine unattended in rooms
with children.
앬
Always pull out the power plug before examining
the electric motor compartment system
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
5. Technical data
Motor rating 1550 W S2 20 min
Motor speed
3000 rpm
AC motor
220 V ~ 60 Hz
Insulation material class
Class B
Protection type
IP54
Table size
630 x 450 mm
Cut length
570 mm
Jolly length
570 mm
Max. workpiece thickness 90°
65 mm
Max. workpiece thickness 45°
48 mm
Diamond wheel
Ø 250 x Ø 25.4
Weight 54
kg
Laser class
2
Laser wavelength
650 nm
Laser output
< 1
mW
Laser power supply
2 x 1.5 V (AAA)
Load factor:
A load factor of S2 20 min (intermittent periodic duty)
means that you may operate the motor continuously
at its nominal power level (1500 W) for no longer
than the time stipulated on the specifications label
(20 minutes ON period).
If you fail to observe this time limit the motor will
overheat. During the OFF period the motor will cool
again to its starting temperature.
Noise emission levels
The noise emitted by this saw is measured in
accordance with EN ISO 3744; EN ISO 11201
The noise at the workplace may exceed 85 dB (A).
The user will require noise protection measures if
this is the case. (Wear ear-muffs!)
Anleitung_RT_SC_570_L_SPK7:_ 04.06.2008 13:55 Uhr Seite 9