EINHELL GE-PH 2555 A, Original Operating Instructions, Page: 15 / 100

4. Technical data
Engine type:
2-stroke engine, air-cooled, chrome cylinder
Engine output (max.): 0.85 kW / 1.15 hp
Displacement: 24.5 cm 3
Idle speed of engine: 3300 min -1
Max. engine speed 8000 min -1
Weight (with empty tank): 5.4 kg
Cutting length: 55 cm
Cutting capacity (max.) 19 mm
Spark plug: Champion RCJ7Y
Max. cutting speed 1900 cuts/min
Sound and vibration
Sound and vibration values were measured in
accordance with ISO 3477, ISO 11201.
L
pA
sound pressure level 98.9 dB(A)
K
pA
uncertainty 3 dB
L
WA
sound power level 110 dB(A)
Vibration emission value (front handle)
Vibration emission value a
h
= 6.41 m/s 2
K uncertainty = 1.5 m/s 2
Vibration emission value (rear handle)
Vibration emission value a
h
= 6.24 m/s 2
K uncertainty = 1.5 m/s 2
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
n
Only use appliances which are in perfect working
order.
n
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
necessary.
n
Switch the appliance off when it is not in use.
n
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
5. Before starting the machine
5.1 Assembly
The hedge trimmer is supplied fully assembled. No
assembly work is required.
To make it easier to control, the machine is fitted with
a rotary handle that can be adjusted as required into
positions at angles of -90°/0°/+90°. To do this, press
the lever (Fig. 5/Item B) downwards, turn the rotary
handle into the required position and then allow the
lever to rise and latch in place again. The various
adjustable positions facilitate working above head
height or in other places with different access.
Important: The rotary handle may only be adjusted
when the engine is switched off.
5.2 Fuel and oil
Recommended fuels
Use only a mixture of normal unleaded petrol and
special 2-stroke engine oil. Mix the fuel mixture as
indicated on the fuel mixing table.
Please note: Do not use a fuel mixture which has
been kept for longer than 90 days.
Please note: Do not use 2-stroke oil with a
recommended mixing ration of 100:1. If inadequate
GB
15
Anleitung_GE_PH_2555_SPK7__ 17.12.14 13:19 Seite 15