EINHELL FBS 62 A, Assembly Instructions Manual

Page: 11 / 28

GB
11
To ensure simple assembly, proceed as follows:
Fig. 12 Securing hood corners (22) to the hood
Push the hood corners (22) onto both corners of hood half 2 and, working from below, tighten the screw (25)
through the hood corner and into the plastic web panel. As a result, the screw is not visible when the hood is
closed.
Fig. 13 Connecting hood half 1 to hood half 2
Insert one hinge clamp (20) into hinge profile of both hood half 1 and hood half 2 on the left and right side.
Fig. 14 Connecting the cold frame parts
a) Connecting the cold frame parts
Connect the individual parts of the cold frame at the top and bottom using a hinge clamp (20). Then push the
hinge strut over the middle hinges on the side parts.
b) Connecting the completed hood to the completed lower section
Insert one hinge clamp (20) each into the hinge profiles of the hood half and the rear part.
Fig. 15 Securing the clips (24) and setting the opening
Push the clips (24) onto the side halves. Three openings can be set. Preferably, one completely opened, one
completely closed and one individually adjustable opening. The cover corners (22) are pushed simultaneously
into the clips (24).
Anleitung FBS 62 A 25.05.2005 8:39 Uhr Seite 11