EINHELL DUAL SPLIT 2500 C+H, Operating Instructions Manual, Page: 11 / 24

GB
11
앬 Never use a combination of new and used
batteries.
앬
Never use a battery type other than the specified
one.
앬 If the remote control is not used for a lengthy
period of time, remove the batteries to prevent
them leaking.
앬
The service life of the batteries if the remote
control is used normally is approximately 12
months.
앬 Dispose of spent batteries properly.
Notes
Keep the remote control approximately 1 m from
television sets or other electrical appliances. Direct
sunlight may considerably reduce the range of the
remote control.
Objects between the remote control and the IR
receiver which can impede reception of the signal
must be avoided. Handle the remote control with
care. Do not drop it, keep it away from heat and
moisture so as not to damage the remote control.
8. Remote control (Fig. 3)
1 Signal output window
2 Function display
3 On/Off switch
4 Function switch (mode switch)
4a Automatic function
4b Cool
4c Dehumidify (Dry)
4d Heat
5
Switch for air circulation velocity
6 Sleep selection key
7 Timer-on key
8 Hours selection switch, minute setting, time
setting
9 Clock setting
10 Temperature adjustment key
11 Key for setting the air flow angle
12 Full blast key
13 Timer-off key
14 Reset key
15 Battery cover opener
9. Functions
A) AUTO (Automatic) mode (Fig. 4)
1. To start
Press the ON/OFF key.
If the automatic function is indicated, the air
conditioner switches to a comfortable room
temperature.
2. To stop the function
Press the ON/OFF key.
NOTE
In AUTO mode the air conditioner will automatically
select on the COOL, FAN and HEAT modes by
detecting the temperature difference between the
actual room temperature and set temperature.
Room temperature
at the start
Function Set-point
temperature
Over +25°C Cool approx. 24°C
+21-25°C Dehumidify ———-
Below 21°C Heat approx. 24°C
Note:
The heat function can be used for outdoor
temperatures down to +7°C. Heating is not possible
if the outdoor temperature is any lower.
B) Cooling, heating and dehumidifying (Fig. 5)
To select cool, dehumidify or heat:
1.
Press the ON/OFF key.
2. Press button 4 to select the appropriate function.
Every time you press the key the function
changes in the following sequence: Automatic -
Cool - Dehumidify - Heat
3. If you wish to switch off the device, press the
ON/OFF button. Once the device has been set
for the first time, all you have to do to return to
the previous function is press the ON key.
Notes:
The heat function can be used for outdoor
temperatures down to approx. +7°C. The maximum
room temperature to be reached depends on the
outdoor temperature and the nature of the particular
building. If during operation the room temperature is
more than 2°C above (cool) or less than 2°C below
(heat) the set-point temperature, the set-point
temperature on the air conditioner cannot be
changed.
As soon as the temperature difference between the
room temperature and the predefined set-point
temperature is less than 2°C again, it will be possible
to change the set-point temperature on the air
conditioner again. The lower the outdoor
temperature, the lower the room temperature that
can be achieved with the heater function.
Changing the temperature
Press the “too hot” key to reduce the temperature.
Each press of the key reduces the set temperature
Anleitung_Dual_Split_2500_C_H_GB:_ 24.01.2008 8:17 Uhr Seite 11