4. Technical data
Engine type
2-stroke engine, air-cooled, chrome cylinder
Engine power (max.)
0.8 kW/1.1 hp
Displacement
30.3 cc
Idle speed of engine
2800 +/- 200 rpm
Max. engine speed
Scythe
8,500 rpm
Trimmer
7,400 rpm
Max. twin line speed
Scythe
6,375 rpm
Trimmer
5,550 rpm
Ignition
Electronic
Drive
Centrifugal clutch
Weight (with empty tank)
7.0 kg
Long handle length
149.5 cm
Cutting circle diameter of line
Ø 41 cm
Cutting circle diameter of blade
Ø 23 cm
Cutting line length
8.0 m
Cutting line diameter:
2.0 mm
Tank capacity
0.8 l
Spark plug
NGK BPMR7A /
Champion RCJ6Y/LDL7T / L8RTF
Vibration a
hv
Idling speed (max.)
5.8 m/s
2
Idling speed (max.)
7.9 m/s
2
L
pA
sound pressure level
100 dB (A)
L
WA
sound power level
108 dB (A)
5. Installation
5.1 Installing the long handle
Install the long handle as shown in Figures D1 – D3.
Do not tighten the screws until you have set the
perfect working position with the carrying strap. The
long handle should be aligned as shown in Figure A.
5.2 Fitting / Replacing the blade (Fig. E1 – E3)
When the machine is supplied the blade is ready-
fitted. Therefore we will first explain how to remove it.
Line up the hole in the carrier plate (Fig. E1/ Item
26) with the notch beneath it and lock the carrier
plate with the size 6 Allen key (Fig. E1/E2)
Remove the securing nut for the blade using the
supplied spark plug wrench (Fig. E2).
Important
:
Left-hand thread!
Remove the pressure plate cover (Fig. E3/Item
26) and the pressure plate (Fig. E3/Item 27)
The blade (Fig. E3/Item 4) can now be removed.
To assemble, proceed in reverse order. Please
note that the side of the pressure plate (Fig.
E3/Item 26) with the recess must point towards
the blade.
5.3 Installing the cutting line guard hood
Important
: The cutting line guard hood must be fitted
if you wish to work with the cutting line.
The guard hood for the cutting line must be installed
as shown in Figures F1 – F3.
A blade (Fig. F6/ Item A) on the underside of the
guard hood automatically cuts the cutting line to the
optimum length. This is covered by a guard (Fig.
F6/Item B).
Remove the guard before you start working and
replace it when you have finished working.
5.4 Fitting / Replacing the line spool
Line up the hole in the carrier plate with the notch
beneath it and lock the carrier plate with the size 6
Allen key (Fig. F4)
Secure the line spool on to the locating pin (Fig. F5).
Important:
Left-hand thread!
To dismantle, proceed in reverse order.
5.5 Mounting the blade guard hood
Important: The cutting blade guard hood must be
fitted if you wish to work with the cutting blade. The
guard hood for the cutting blade must be installed as
shown in Figures F7 – F9.
19
GB
Anleitung_BG_BC_30_1_SPK1:_ 04.09.2008 15:53 Uhr Seite 19
