16
GB
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machineʼs construction and
design:
n
Contact with the cutting-off wheel in the un-
covered cutting zone.
n
Reaching into the cutting-off wheel while it is
running (injuries through cutting).
n
Kick-back of workpieces and parts of work-
pieces.
n
Broken cutting-off wheels.
n
Catapulting of damaged or cutting-off wheels.
n
Damage to hearing if ear-muffs are not used as
necessary.
4. Technical data
AC motor
230 V ~ 50 Hz
Power P
2550 W
Idle speed n
0
3800 min
-1
Cutting-off wheel
Ø 355 x Ø 25.4 x 3.2 mm
Footprint
480 x 277 mm
Swiveling range
0 - 45°
Vise clamping range max.
195 mm
Saw width at 90°
Ø 70 / 105 x 45 mm
Saw width at 45°
85 x 45 mm
Weight 17.5
kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L
pA
sound pressure level
101 dB(A)
K
pA
uncertainty 3
dB
L
WA
sound power level
114 dB(A)
K
WA
uncertainty 3
dB
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Keep the noise emissions and vibrations to a
minimum.
n
Only use appliances which are in perfect working
order.
n
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
necessary.
n
Switch the appliance off when it is not in use.
n
Wear protective gloves.
5. Before putting the machine into
operation
n
Unpack the metal cutting-off machine and check
it for damage which may have occurred in
transit.
n
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong base.
n
All covers and safety devices have to be pro-
perly fitted before the machine is switched on.
n
It must be possible for the cutting-off wheel to
run freely.
n
Before you actuate the ON/OFF switch, make
sure that the cutting-off wheel is correctly fitted
and that the machineʼs moving parts run
smoothly.
n
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
n
Release the (13) locking device.
6. Assembly
Important. Always pull out the power plug before
carrying out maintenance, resetting or assembly
work.
6.1 Transport brace / carry-handle (Fig. 1 / 2)
n
Push saw head (1) down with the handle (2) and
pull out the locking device (13).
n
Slowly raise the saw head (1).
Caution! The resetting spring lifts the saw head
(1) automatically. Therefore, do not simply let go
of the handle (2) after cutting, but allow the saw
head (1) to rise slowly by applying slight
counterpressure.
n
Fig.1 shows the saw head (1) in its upper
position.
n
For transporting, the saw head (1) should be
locked in the lower position with the locking
Anleitung_BT_MC_355_SPK7__ 19.10.12 10:38 Seite 16
