1. Assembling the base frame (Fig. 1-3)
앬
Place the base frame (1) on a surface with the
underside facing upwards. Fit the transport
wheels (2) as shown in Figure 1 using one screw
(3) and one lock nut (4) on each wheel.
앬
Pull the frame (5) until it is released from the lock.
Then pull the frame (5) upwards until it locks.
Proceed with the frame (6) in the same way.
2. Attaching the device to the base
frame (Fig. 4-5)
앬
Place the base frame (1) on a level surface.
Place the saw on the base frame (1) in such a
way that the screws fit through the mounting
holes. Secure the saw to the base frame (1)
using the hex screws (7) and washers (8).
3. Transport (Fig. 6)
앬
Remove all the parts of the saw that could make
transport more difficult. Pull the frame (6) until it
is released from the lock. Then fold the frame (6)
inwards until it locks. Proceed with the frame (5)
in the same way. Pull out the transport handle (9)
and transport the saw as shown in Figure 6.
4. Installing the base frame with device
attached (Fig. 7 - 8)
앬
Hold the base frame by the handle (9) and pull
the frame (5) until it is released from the lock.
Fold out the frame (5) until it snaps into place.
Then set down the base frame and lift it up as
shown in Figure 8. Use the same procedure for
the frame (6).
Important.
There is no saw supplied with the
base frame!
5. Maintenance
앬
In order to ensure good mobility of the
components, dirt must be removed regularly and
all moving parts (rollers, extension arms) must be
lubricated at regular intervals. Cleaning is best
carried out with compressed air or a cloth.
앬
Never use caustic agents to clean parts.
5
GB
Anleitung Untergestell_SPK1:Anleitung Untergestell_D 09.05.2008 11:23 Uhr Seite 5
