6
the minimum distance to the housing, or the
installation height, has to be measured from the
top of the skirting.
Then drill the two fastening holes with 6 mm
diameter. The centers of the holes must be
marked so that they are 167 mm apart and
horizontal (Fig 2) and at least 1500 mm above
the floor (allow for skirtings) and the holes drilled
accordingly.
Insert wall plugs in the drilled holes, screw in the
screws and hang the heater on the wall.
4. Technical data:
Rated voltage:
230 V ~ 50 Hz
Output:
16
00 W (
8
00 W /
16
00 W)
Protection type:
IP24
Appliance dimensions, approx.:
27 x 13 x 37 cm
5. Proper use
The appliance is designed only for private use, not
for commercial heating purposes.
6. Starting up
Important! Before using the appliance for the first
time, check that the voltage supply is the same as
the voltage details set out on the data plate. Read
safety instructions listed under section 1.
When the heater is used for the first time or after a
long period of rest it may emit an odor for a short
time. This is not a fault.
6.1 Switch for heat output (Fig. 1 / Item 1)
Important!
The switch is to be operated only in anticlockwise
direction.
Off setting (0)
Fan setting (1)
Low heating output (2)
8
00 W
Maximum heating output (3)
16
00 W
The switch can also be actuated with the pull cord
(Fig. 1/Item 4).
6.2 Overheat cut-out
In case of excessive heating, the heating function
shuts down automatically. If this case occurs, turn off
the appliance, disconnect the mains plug and wait a
few minutes until it has cooled. After eliminating the
cause (e.g. a covered air grille), the appliance can be
switched on again. If the overheat cut-out triggers
repeatedly, please contact your customer service
center.
7. Maintenance and cleaning
Before carrying out any cleaning and maintenance
work the appliance must be turned off,
disconnected from the power supply and cooled
down.
Maintenance and repair work may only be carried
out by an electrical servicing contractor or your
customer service center.
Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead may
only be replaced by an electrician or the customer
service responsible for your country in compliance
with the relevant regulations.
Use a damp cloth to clean the casing.
Remove dust pollution with a vacuum cleaner.
8. Storage
The radiator has to be stored in a dry place, covered
if possible.
9. Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of machine
Article number of the machine
ID number of the machine
Number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
GB
Anleitung BH 2000_SPK1 16.08.2006 15:26 Uhr Seite 6
