EINHELL 11032, Original Operating Instructions

Page: 16 / 80

measurements and cleaning jobs only when the
motor is switched off. Pull the power plug!
n
Before switching on, make sure that all keys and
wrenches have been removed from the tool.
n
Switch off the motor and pull the power plug
before you leave the workplace.
n
Refit all guards and safety devices immediately
after you have completed any repairs or
maintenance work.
n
Be sure to observe the safety information and
operating and maintenance instructions issued
by the manufacturer, as well as the dimensions
listed in the Technical Data.
n
It is imperative to observe the accident
prevention regulations in force in your area as
well as all other generally recognized rules of
safety.
n
Note the information published by your
professional associations (VBG 7j).
n
The circular saw has to be connected to a 230 V
socket with a 16 A fuse.
n
Do not use the cable for purposes for which it is
not designed.
n
Make sure you stand squarely and keep your
balance at all times.
n
Check the tool for damage.
n
Each time before re-using the tool, carefully
check that the guards or any slightly damaged
parts are working as intended.
n
Check that the moving parts are in good working
order, that they do not jam, and that no parts are
damaged. Make sure that all parts are fitted
correctly and that all other operating conditions
are properly fulfilled.
n
Unless otherwise stated in the operating
instructions, damaged safety devices and parts
must be repaired or replaced by an authorized
service center.
n
Have damaged switches replaced by a customer
service workshop.
n
This electric tool complies with the pertinent
safety regulations. Repairs are to be carried out
only by a qualified electrician using original
replacement parts or the user may suffer an
accident.
n
If necessary, wear suitable personal protection
equipment. This could consist of:
- Ear plugs to prevent the risk of damaging your
hearing;
- A breathing mask to avoid the risk of inhaling
hazardous dust.
- Always wear gloves when handling saw blades
and rough materials. Whenever practicable, saw
blades must be carried in a container.
n
The operator must be informed about the
conditions that influence the generation of noise
(for example saw blades designed to reduce
noise emissions, caring for blades and the
machine).
n
Faults on the machine or its guards, safety
devices and blade must be reported to the
person in charge as soon as they are
discovered.
n
Use only the transport devices to move the
machine. Never use the guards for handling and
moving the machine.
n
All operators must receive proper training in the
use, adjustment and operation of the machine.
n
Do not saw any materials that contain foreign
bodies such as wires, cables or ties.
n
Only use sharp saw blades.
n
Stack the workpieces you want to work on as well
as the finished workpieces near your working
position.
n
Note the maximum speed which is printed on the
saw blades.
n
Make sure that the flanges used are suitable for
the intended purpose as specified by the
manufacturer.
n
Adopt the safe working practices for cleaning and
maintenance and for the regular removal of chips
and dust in order to prevent a risk of fire.
n
The saw is allowed to be used only when all the
safety devices are fitted and their proper
operation has been checked.
n
Throughout the machine’s anticipated service life,
make sure that the machine and its components
cannot topple, fall over or move out of control
during transport, assembly, disassembly,
disabling and scrapping.
Sound and vibration
Sound and vibration values were measured in
accordance with EN ISO 3744.
mode
L
pA
sound pressure level 90 dB(A)
K
pA
uncertainty 4 dB
L
WA
sound power level 113 dB(A)
K
WA
uncertainty 4 dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
GB
16
Anleitung_BT_LC_500_SPK7__ 22.08.12 10:14 Seite 16