10
Caution:
Laser radiation.
Do not look into the beam!
Laser class 2
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces,
persons or animals. Even a low output laser beam
can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open laser module.
When the tool is not going to be used for an
extended period of time, the batteries should be
removed.
1. Description of the machine (Fig. 1/2)
1
1. Base frame
1
2. Diamond wheel
1
3. Trough
1
4. Work table
1
5. Angle stop
1
6. Rail fence
1
7. Guide rail
1
8. Safety hood for the cutting wheel
1
9. Handle
10. Star grip screw for setting the angle
11. Star grip screw for securing during transportation
12. Base frame
13. Cooling water pump
14. Hose
15. Motor
2. Items supplied
Tile cutting machine
Trough (3)
Cooling water pump (13)
Angle stop (5)
Base frame (1)
3. Intended use
The tile cutting machine is designed for the standard
cutting of small and medium-size tiles (glazed tiles,
ceramic tiles or similar) which can be accommodated
by the size of the machine. It is designed for DIY
applications and craft businesses in particular. It
should never be used for the cutting of wood or
metal.
The machine should be used exclusively
for its intended purpose.
No other use is permitted
and the manufacturer will not accept liability for any
damages or injury resulting from any such use;
responsibility rests with the user/operator in any such
case. Only use cutting wheels which are suitable for
the machine. Saw blades should never be used.
Compliance with the safety instructions, the
assembly instructions, and advice and instructions
on operation contained in the operating instructions
also falls under the terms of intended use. All
persons operating or carrying out maintenance work
on the machine must be acquainted with the above
and be aware of all potential dangers.
In addition, strict compliance with the accident
prevention regulations in force in your area, as well
as all other general rules of health and safety at
work, is imperative. The manufacturer’s liability shall
be deemed void if the machine is modified in any
way and the manufacturer shall therefore accept no
liability for any damages arising as a result of
modifications. Even if the machine is used as
intended, certain residual risk factors cannot be
completely eliminated. For reasons of design and the
construction of the machine, the following
eventualities are possible:
Contact with the diamond cutting wheel where it
is not covered.
Contact with the diamond cutting wheel while it is
turning.
Defective diamond tips flying off the cutting
wheel.
Workpieces or parts of workpieces kicking back.
Damage to hearing if the ear-muffs specified are
not used.
4. Important instructions
4.1. General
Please read this manual carefully and pay particular
attention to the instructions contained within it. Use
this information to get to know the machine, its
correct operation and safety regulations (see
supplementary sheet) before using for the first time.
GB
Ꮩ
Achtung
Laserstrahlung
Nicht in den Strahl blicken!
Laserspezifikation
nach EN 60825-1: 2001
Laser Klasse 2 1894S-8X17
Ï
: 650 nm
P: < 1 mW
Anleitung NRF 800L_SPK1 25.09.2006 8:48 Uhr Seite 10
