Eilon Engineering Ltd. RON 2501 NG Operating Manual
14
When the known weight is ready on the display press ENTER. The display will
show “APPLY” meaning apply the known weight for calibration. Apply the load.
Wait until it has stopped moving and then press ENTER. The display will show
“WAIT” for a few seconds and then CALIB. Press ESC. The system returns to
measuring mode.
If at any stage during the procedure one wishes to quit, press the ESC key. The
system will return to measuring mode. If it does not do so, switch the system
“OFF” and “ON” again.
If the calibration procedure is terminated before completion by pressing “ESC” or
by switching off, it will cause the part of the procedure that has already been
completed to be erased.
8. OPTIONS
To enter the options programming procedure one must use the main code which is:
press: ESC + ENTER simultaneously. CODE? will be displayed. Press MAX (until
the beep is heard) and then ZERO (until the beep is heard).
The display responds by showing the first option function.
If the code is not accepted, FAIL will be displayed.
Try the entire code procedure again from the beginning.
To change the displayed option press the arrows up, or down until the option
you require is found. To enter the calibration procedure you will be requested to
use an additional code which is described in CALIBRATION chapter #7.
8.1 SET POINTS – ADJUSTING & GENERAL SCHEME
To enter the programming procedure menu options follow the instructions in
chapter #8. Select the SET P by using the down and up arrows.
Press: ENTER.
S/P 1 is displayed.
Press: ENTER.
The display will show the units in use by blinking and then the set point 1
current level value.
To adjust the new set point desired level, press the up and down arrows. See
the guide points in chapter #7 CALIBRATION.
After obtaining the desired level on the display press ENTER.
