9
Safety operation guideline
Light Module
●
A light module containing multiple laser diodes is equipped in the product as the light source.
●
These laser diodes are sealed in the light module. No maintenance or service is required for
the performance of the light module.
●
End user is not allowed to replace the light module.
●Contact qualified distributor for light module replacement and further information.
About High Altitude mode
●
Set [HIGH ALTITUDE] to [ON] in the Setting menu when using the projector at altitudes ap-
proximately 1700 meters or higher.
Using the projector at altitudes approximately 1700 meters or higher without setting to [HIGH
ALTITUDE] can cause the projector to overheat and the protector could shut down. If this
happens, wait a couple minutes and turn on the projector.
●
Using the projector at altitudes less than approximately 1700 meters and setting it to [ON] can
cause the light module to overcool, causing the image to flicker. Switch [FAN MODE] to [OFF].
●
Using the projector at altitudes approximately 1700 meters or higher can shorten the life of
optical components such as the light module.
!
Caution-CLASS 1 LASER PRODUCT OF IEC 60825-1 THIRD EDITION
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
!
RG3 PRODUCT OF IEC/EN 62471-5 FIRST EDITION
●
No direct exposure to the beam shall be permitted, RG3 IEC/EN 62471-5:2015".
●
Operators shall control access to the beam within the hazard distance and install the
product at the height that will prevent exposures of spectators' eyes within the hazard
distance.
Laser safety caution
●This product is classified as Class 1 of IEC 60825-1 Third edition 2014-05 and RG3 of IEC/EN
62471-5 First edition. Obey the laws and regulations of your country in relation to the installa-
tion and management of the device.
●
Regarding the installation and management of the equipment, please comply with the relevant
laws and regulations of your country.
●
Outline of laser emitted from the built-in light module:
Wavelength: 455 nm
Maximum power: 257W(EK-1100LU);229W(EK-850LU)
●
Radiation pattern from the protective housing::
Wavelength: 455 nm
Maximum laser output: : 333mW
●
The laser module is equipped in this product. Use of controls or adjustments of procedures
other than those specified herein may result in hazardous radiation exposure.
Summary of Contents for EK-1100LU
