48
Expand
This function is used to set the internal test
signal: Gray scale 1, Gray scale 2, Gray scale
3, Gray scale 4, Color bar, Red, Green, Blue,
Cross hatch, White, Black and Raster gray.
When you get into the Test Pattern mode,
press MENU to get back the selection page of
Test Pattern.
Test Pattern
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter
Test Pattern
Function : PC controls projector via LAN.
Preparation:
1. Equipments: PC, projector, cables
2. Connection procedures:
Connect the projector to routers or switches of the LAN by direct or cross cable. If it fails to
connect PC and projector by parallel cable, please switch to cross cable as suggested.
3. After the computer is booted and the projector is plugged in, indicator lights of LAN interface
on will fl ash continuously.
Network
Operation procedures:
1 Turn on the projector.
2 Obtain network address. DHCP set is
displayed as On and obtain network address
automatically.( If familiar with network, you
can set DHCP as Off and obtain network
address manually.)
3 Enter network settings menu.
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter
Filter check
Check the temperature iside the projector and make reactions.
On: enable the fi lter check function
*when the projector checked any filter issue the warning message would pop-up
automatically
Off: disable the fi lter check function
Note:
● When the lamp counter is less than 50 hours, and the projector has checked fi lter warning
condition, there won't pop-up the warning message but the fi lter check function would change
the seeting from On to Off automatically.
● The warning message will automatically disappear after 30 seconds, there only the power
button is effective during that period.
● The warning message will pop-up again if the projector has checked the fi lter warning
condition.
● The checking term of fi lter check function is every 10 minutes after power on the projector.
And the projector would stop to check the fi lter condition after the 3rd term (30 minutes).
