Eight CENTURY CC1, Manual

Page: 7 / 14

DISPLAY READOUT EXPLANATION
Tap Add Channel to add channel.
Up to 6 channels can be added at once.
First select the starting channel (e.g. CH5) and tap to confirm.
Then select the stop channel (e.g. CH7, this means that you will
add 3 channels). Tap to confirm. Then you can convert them using
the rotary button (e.g. CH5 to CH7 converts to CH8 to CH10) and
tap to confirm.
Some other examples:
To add CH5 and convert to CH6,
select as follows: 5: 5

6: 6
To add CH21-22-23 and convert to CH31-32-33, select as follows:
21:23

31:33
Remark 1: The value 85dBµV (in the bottom right corner) indicates
the incoming level of the channel.
Remark 2: For EU, Italy and New-Zealand region, Channel 13 (230-
240MHz) can be used. CH13 cannot be converted.
For optimal performance we recommend to only add single channels, unless you need to process
a lot of channels.
DISPLAY READOUT EXPLANATION
To add another (group of) channel(s), scroll down to ADD CHANNEL
and tap to confirm.
To prevent bad quality or scrambled images, make sure that only
one input channel is assigned to one output channel. If 2 channels
are assigned to the same output channel, a star (

) will appear.
The same applies for adding multiple channels. Make sure that each
output channel is selected only once.
After this, the correct LTE filter will be set for the UHF inputs (possible filters are 694MHz, 790MHz or OFF). If the
channels are lower than 48, the 694MHz filter is activated. The 790MHz filter is activated for the channels lower than
60.
To delete a (pair of) channel(s), position the arrow on the channel and press
the rotary button 3 seconds.
P.7