Eicon EiconCard P92, Installation Manual

Page: 24 / 32

24 EiconCard P92 Installation Guide
Users should ensure for their own protection that the electrical ground connections
of the power utility, telephone lines and internal metallic water pipe system, if
present, are connected together. This precaution may be particularly important in
rural areas.
Caution:
Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or electrician, as appropriate.
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les
limites applicables aux appareils numériques de la classe B prescrites dans le
Règlement sur le brouillage radioélectrique édicté par le ministère des
Communications du Canada.
Regulatory Information for Europe
This equipment displays the CE168 mark to show that it has been tested and found
to fully comply with the Terminal Equipment, EMC and Low Voltage Directives (91/
263/EEC, 89/336/EEC and 72/23/EEC, as amended by Directive 93/68/EEC).
Safety Status: SELV
No voltages within this equipment exceed SELV voltages. All interconnection points
and ports are SELV.
User/Installer Instructions for the United Kingdom
EiconCard P92 Communications Board
Important Safety Considerations When Installing Into A Host
Computer System
The EiconCard P92 is a half-length PCI compatible card.
The EiconCard P92 is approved only for installation in an EN60950 approved host,
surrounded by a minimum 2.5 mm air gap, and with host attachments which are
either type approved for such apparatus, or, if supplied after March 1, 1989, are
marked with or supplied with a statement that the host is supplied under: GENERAL
APPROVAL NUMBER NS/G/1234/J/100003.
Installation Within A Spare Slot Position
In order to comply with Safety Regulations particular care should be taken to ensure
adequate separation between the EiconCard P92, the components mounted on it, and
any adjacent modules.
Except at the edge connector which plugs into the host’s expansion slot, clearance
and creepage distances of X mm and Y mm, as listed in Table 10, must be maintained
between the EiconCard P92 card and other parts of the host including any other
expansion cards fitted.
203086-1.FM5 Page 24 Friday, February 28, 1997 10:35 AM