EIBENSTOCK PLB 450 G, Original Instructions Manual

Page: 18 / 40

17
Drilling
Inclined drilling
Remove the screw, which locks the column at 90°.
Open the top screw of the support with the turnstile.
Place the column into the desired position and
screw the support at the appropriate hole on back.
At the beginning, drill very slowly, since the drill bit does only starts cutting with a
fraction of the cut surface in the material. If you drill too fast or with too much
pressure, the drill bit could get jammed.
In order to reach the max. drilling depth, you probably have to use an
extension for the drill bit!
The different adjustable tilt angles are marked on the
column.
After drilling put the column back in the 90°position.
Important!
Necessarily secure column at 90 ° with the screw!