Depending on the Alarm models you purchased, the RadioLINK module may have
been supplied with the unit or you may have to purchase it separately.
When fitting or removing the RadioLINK module, please hold using the pull tab
attached to it. Also tuck the tab between the Alarm housing and the module when
it is installed in order to avoid it being fouled up with the mounting plate.
Testing
Your Alarm is a life saving device and should be checked periodically. Regularly
check that the red light on the Alarm flashes approx once a minute to show the units
are powered. Replace the Alarm if the flashing stops.
Manually Testing your Alarms
It is recommended that you test your Alarms after installation and then at least
weekly to ensure the units are working. It will also help you and your family to
become familiar with the sound of the Alarms.
- Press and hold the Test Button until the Alarm sounds and the red light flashes
The Alarm will stop sounding shortly after the button is released.
- If they are interconnected using RadioLINK modules, hold down the Test button until
the blue light on the cover of the Alarm illuminates. Check that all other Alarms sound.
- Release the Test button. The Alarm and all connected Alarms should stop
sounding.
- Repeat this procedure for all other Alarms in the system.
WARNING: Do not test with flame.
8
B16971-R0-Ei600 RF-U&C 28/6/10 12:13 PM Page 8
