Ei Electronics Ei3000 Series, Instruction Manual

Page: 27 / 44

27
5.2 Module Status
5.2.1 House Code
To enter house code mode, hold the House Code Button until the blue LED lights solid and
then release. The blue led will then flash rapidly for a few seconds to indicate the module is
in house code mode. The blue led will then flash every 5 seconds for each house code serial
number that it learns.
To exit house code mode, hold the House Code Button until the blue LED lights and
then release. The module will then transmit a learn exit message (3.5 second blue flash).
Alternatively, the module will exit house code mode after 30 minutes.
5.2.2 Factory Reset
To factory reset the module, hold the House Code Button until the blue LED flashes and then
release. The blue LED will then flash rapidly for a few seconds to indicate a successful reset
followed by a single blue flash.
5.2.3 Remote Learn Entry
To activate remote learn entry, hold the House Code Button until the LED flashes
red-blue-green and then release. The blue LED will then flash rapidly for a few seconds to
indicate the mode activation, followed by a 3.5 second blue flash. Remote learn entry is only
possible if successful house coding has been previously completed.
5.2.4 Monitoring
Monitoring is only possible if successful house coding has been previously completed and
should only be initiated on one device in the network.
To enable Monitoring, hold the House Code Button until the green LED lights solid and then